Design Basis
In Pressure Seal WC6 Gate Valve Class 900, the Pressure Seal Gate Valve construction determines the closure support, body arrangement and maintenance approach. Confirm bore or flow path, body joint, stem/shaft retention, seat support, anti-blowout features where applicable and access requirements against the approved GA.
Pressure-Boundary Material
For Pressure Seal WC6 Gate Valve Class 900, the pressure boundary is WC6. Cast chromium-molybdenum alloy steel for elevated-temperature pressure service. Because this valve is Class 900 with RF / RTJ / BW, verify the material condition, trim compatibility, bolting and any PMI/NDE or corrosion-control requirement as one package.
Pressure Class and Piping Interface
For Pressure Seal WC6 Gate Valve Class 900, the specified rating is Class 900 and the piping interface is RF / RTJ / BW. High-pressure service where end preparation, wall section and operating loads need tighter coordination. Raised-face, ring-type-joint or butt-weld ends change flange/gasket or weld preparation and should be fixed before drawing approval. Final dimensions and pressure-temperature suitability must therefore be checked against the selected material and design temperature, not inferred from class alone.
Seat and Seal Arrangement
For Pressure Seal WC6 Gate Valve Class 900, the listed sealing basis is Metal Seat. Metal seating shifts the design toward hardfacing/coating, lapping, higher torque and wear control rather than polymer-seat compliance. Confirm leakage acceptance, pressure/temperature limits and cycling together with the Class 900 loading and the selected Gear / Actuator operating method.
Operation and Actuation
For Pressure Seal WC6 Gate Valve Class 900, operation is Gear / Actuator. Gear or powered actuation should be selected from the valve torque curve, maximum differential pressure, operating frequency and required closing time. The final operator or actuator basis should use the actual size, maximum differential pressure, Metal Seat friction/seating behavior and required operating or emergency time.
Service Conditions
No service qualifier is fixed by the product name, so Pressure Seal WC6 Gate Valve Class 900 should be released only after the actual fluid, temperature range, pressure cases, cycling and special service requirements are known.
Inspection and Testing
For Pressure Seal WC6 Gate Valve Class 900, tie MTC/heat traceability, dimensional inspection, PMI/NDE where specified, shell/seat testing, coating checks, witness points and final records to the approved ASME B16.34 datasheet and ITP.
Documents Before Release
The manufacturing release for Pressure Seal WC6 Gate Valve Class 900 should reference the approved GA, material/trim schedule, seat/seal definition, operator or actuator data, test scope and required final documentation.